Instructions / Assembly

Customer Service: 800-626-1126 | rev-a-shelf.com
4
Attach slide half of side-mount
bracket to front of slide with two
screws per slide. (Fig F)
STEP 1
Snap two cover caps to the studs
on the front side of the basket.
(Fig I)
STEP 4
Side Mounted:
Front
Back
38
mm
min
1
3
/
4
”
88
mm
64
mm
64
mm
B
C
C
A
Side Dimension
E
1
1
/
2
”
2
17
/
64
”
3
1
/
2
”
2
17
/
64
”
45
mm
J
I
K
Location of the bottom of basket
Front outside edge of cabinet / back of door
1 - 3/4”
(45 mm)
“n” Shape Mounting
“s” Shape Mounting
(if needed to avoid door hinges)
2 - 3/8”
(60 mm)
(Minimum to provide
clearance from
cabinet oor)
Inside edge of 3/4” face frame
(with enough clearance to work properly)
- Place template at the front edge of your cabinet opening at desired height
- Use reverse side of template for other side wall and repeat
5730/5786 SERIES PULLOUT BASKET WITH SOFT-CLOSE
Side Mounting Template (Left)
I
X4
7
64
3
32
T-57XSM-1015
2
mm
Fig F)
Fig G)
Use Side Mounting Template
to install cabinet half of side-
mount bracket .
(Fig G)
STEP 2
Place slide assembly on top of
cabinet mount bracket, insert
screws, adjust to the desired
width of basket and tighten
screws. Repeat on opposite wall.
(Fig H)
NOTE
If door mounting, skip to page 6.
STEP 3
Place basket on top of slides and
push back until the basket locks
under the tab at the rear and the
button on the side. (Fig J)
NOTE
You should hear the button click
when engaged.
STEP 5
Center point of cabinet
Back of Door / Front Edge
12 15 12 15
2”
(50 mm)
10 - 1/4”
(260 mm)
5730/5786 SERIES PULLOUT BASKET WITH SOFT-CLOSE
E F G
H
I
J
Bottom Mounting Template
12 15 12 15
J
X8
L
X8
T-57XBM-1015
7
64
3
32
2
mm
Center point of cabinet
Back of Door / Front Edge
12 15 12 15
2”
(50 mm)
10 - 1/4”
(260 mm)
5730/5786 SERIES PULLOUT BASKET WITH SOFT-CLOSE
E F G
H
I
J
Bottom Mounting Template
12 15 12 15
J
X8
L
X8
T-57XBM-1015
7
64
3
32
2
mm
X4
X4 (per side)