Installation Guide

Illustration 1
Installation Instructions for:
548 Series
Pull-Out Wire Baskets
Step 1 - Frame or Frameless
Cabinet Installation
Position basket level in cabinet
against left or right side wall
flush with front cabinet
opening and mark upper and
lower slide screw locations
on cabinet wall with a pencil.
Make sure to allow enough
clearance beneath basket to
allow for smooth travel when
sliding unit out of cabinet.
(Illustration 1)
2409 Plantside Dr. • Jeffersontown, KY 40299
800-626-1126 • 502-499-5835 • FAX: [phone]
Illustration 2
Step 2 - Attaching
spacers and
slides to cabinet
Attached spacers to cabinet
wall at the locations you
marked by using the eight
(8) provided #8 x
11
⁄
16
” flat
head screws.
(Illustration 2)
Secure slides to spacers
by screwing the four (4)
provided #6 x
5
⁄
8
” flat head
screws through the slide
and into the spacers.
(Illustration 2.1)
548-10
Illustration 3
Step 4
Hang basket over four support screws. Tighten
screws so that basket is snug to slides. Your
installation is now complete!
Step 3 - Attaching basket to slides
Attach basket to slides using the four (4) provided
4mm pan head screws. Attach screws to slide
allowing
1
⁄
8
” clearance so basket can hang over
screws. (Illustration 3)
Illustration 2.1
#8 x
11
⁄
16
”
Flat #6 x
5
⁄
8
”
Flat 4mm Pan
Head Screw Head Screw Head Screw
Tools required: #2 Phillips Screwdriver, Level, and Pencil