Installation Guide

Illustration 1
Installation Instructions for:
548 Series
Pull-Out Wire Baskets
Step 1 - Frame or Frameless
Cabinet Installation
Position basket in cabinet
against left or right side wall
flush with front cabinet
opening and mark upper and
lower slide screw locations on
cabinet wall with a pencil. Make
sure to allow enough clearance
beneath basket to allow for
smooth travel when sliding unit
out of cabinet. (Illustration 1)
I-548
Illustration 3
Step 3 - Attaching basket
to slides
Attach basket to slides
using the four (4) provided
4mm pan head screws.
Attach screw through
basket and into slide.
(Illustration 3)
Your installation is now
complete.
548-06
Tools required: #2 Phillips Screwdriver, Level, and Pencil
NOTE: For Door-Mount Installation
Follow above steps 1 thru 3. Use four (4) additional
wood screws (Not Supplied) to attach door front to
wire basket (Not recommended for doors larger than
9” wide). If door mounting in frameless cabinet
without hinges installed, eliminate spacers and
attach slides directly to cabinet wall with the four
(4) provided #8 x 11/16” flat head screws.
2409 Plantside Dr. • Jeffersontown, KY 40299
1-800-626-1126 • 502-499-5835 • FAX: [phone]
#8 x
11
⁄
16
”
Flat #6 x
5
⁄
8
”
Flat 4mm Pan
Head Screw Head Screw Head Screw
Illustration 2
Step 2 - Attaching
spacers and
slides to cabinet
Attached spacers to cabinet
wall at the locations you
marked by using the eight
(8) provided #8 x
11
⁄
16
” flat
head screws.
(Illustration 2)
Secure slides to spacers
by screwing the four (4)
provided #6 x
5
⁄
8
” flat head
screws through the slide
and into the spacers.
(Illustration 2.1)
Illustration 2.1
A3OISTR0230, December 2004