Installation

INSTALLATION INSTRUCTIONS: 5374 SERIES SWING OUT PANTRY 3
Optional bracket
Screw the sliding pin into the
frame using the provided
M5x14 screws so the pin is on
the hinge side of the pantry
frame (See Fig 4A). Insert the
frame into the pantry, ensuring
the sliding pin attaches to the
lateral slide and the (4) holes
at the bottom of the frame
line up with the (4) holes on
the bottom slide. Attach the
frame to the bottom slide with
the provided (4) M6x40 screws
(See Fig 4B).
STEP 4
LEFT
SIDE
HINGES
M5X14 SCREWS
M6X40 SCREWS
M5X14 SCREWS
RIGHT
SIDE
HINGES
FIGURE 4A
FIGURE 4B
#2
#2
2
N°2 M5x14
N°4 4x16
1
Installare la guida laterale C sul fianco del mobile, rispettando
le quote.
Install the lateral slide C on the side cabinet respecting the
quotes.
Installez la coulisse latérale C dans la côté du meuble et re-
spectez les cotes.
Instalar la guía lateral C en el lado del mueble siguiendo las
medidas.
Installare un piedino (non fornito) al centro del mobile.
Una volta scelto il verso dell’apertura dell’anta, utilizzare le
2 viti M5x14 per avvitare il perno di scorrimento D nel telaio A
affinché lo stesso perno si trovi nel lato cerniera.
Place a foot (not supplied) in the centre of the furniture.
Choose the door opening direction and then screw the sliding
pin D into the frame A by using the two screws M5x14, so that
the pin is in the hinge side of the furniture.
Posez un pied (pas muni) au centre du meuble. Choisissez la
ouv
erture de la porte et après vissez le pivot de coulissement
D avec les deux vis M5x14, afin que le pivot est dans la côté du
meuble où il y a la chernière.
Colocar un pie (no incluido) en el centro del mueble. Elegir la
dirección de apertura de la puerta y después atornillar el pasa-
dor deslizante D en la estructura A con los dos tornillos M5x14,
así que el pasador está en el lado del mueble con la bisagra.
LEFT
RIGHT
LEFT RIGHT
120°120
°
CABINET 300/400
MAX 120°
3
Installare la guida B sul fondo del mobile rispettando le quote
riferite al lato cerniera.
Fixez la coulisse B sur le fond du meuble et respectez les cotes
de côté du meuble où il y a la chernière.
N°6 4x16
N°4 M6x40
4
Inserire il Telaio A e fissarlo tramite 4viti M6x40 (vedi immagine).
Insert the frame A and fix it by using the four screws M6x40, as
per related picture.
59-7/8”
(1521 MM)
1-3/4”
(44 MM)
FIGURE 5A
FIGURE 5B
1-1/8”
(29 MM)
CENTER
BRACKETS
HORIZONTALLY
HINGE SIDE
CABINET DOOR
Optional bracket
1-1/8”
(29 MM)
NOTE: If you have a solid
panel door, skip this step and
proceed to step 6.
Use the measurements in
Figure 5A to determine the
hole locations for both top and
bottom extension brackets.
Then attach your extension
bracket using #8x5/8” athead
screws (See Fig 5B).
STEP 5
#2
Optional bracket
Optional bracket
Optional bracket
Optional bracket
Optional bracket
Optional bracket
4 MM