Installation Sheet
Customer Service: 800-626-1126 | rev-a-shelf.com
8
Place the support arm
template from step 2 on top
of the side bracket as shown in
gure 9. This will give you the
punch locations for the support
arm belonging to the upper
tray. Punch your holes using an
awl and rubber mallet.
STEP 9
To hang the top shelf support
from the telescoping shaft, use
the hook that corresponds with
the desired side bracket level
(See Fig 8.1). Use the template
from step 6 to punch holes
corresponding with desired
tray height See Fig 8.2). Secure
the side bracket to the cabinet
side wall with side bracket
screws (See Fig 8.3).
Secure the top shelf hardware
to the side bracket (See Fig
12.1). Secure to the cabinet
wall using the provided pivot
screw (See Fig 12.2).
STEP 8
STEP 12
FIGURE 8.1 FIGURE 8.2
FIGURE 9FIGURE 8.3
FIGURE 10.2
FIGURE 12.1 FIGURE 12.2
CHOOSE
DESIRED
HOOK
PUNCH
CORRESPONDING
HOLES
ATTACH SIDE
BRACKET
ATTACH
SCREWS
PIVOT
SCREW
Using the provided support
arm screws, secure the upper
and lower support arms to
the cabinet side wall (See Figs
10.1 and 10.2). At this time,
insert the plastic caps into the
support arms as shown.
Secure the guide track to the
cabinet oor using the guide
track wood screws (See Fig 11).
STEP 10
STEP 11
FIGURE 11
FIGURE 10.1
ATTACH
SCREWS
#2
#2
#2
#2
PUNCH
HOLES
ATTACH
SCREWS
INSERT CAP
INSERT CAP