Installation Guide
Tools Required: #2 phillips screw driver, pencil
Note: The wood tiered cutlery divider drawer (WTCD) is designed to use under mount full-extension drawer hardware only. If you are replacing a drawer
box that does not currently use Full-Extension (FX) or Premium Guide (PG) hardware you will need to order a drawer guide kit (DGK).
1. Remove the drawer box from the existing cabinet by squeezing the drawer locking devices and pulling the drawer box forward.
2. Place the drawer box with the drawer front attached face down on a towel laid over a flat smooth solid surface.
3. Using a pencil trace around the bottom two corners of the drawer and onto the back of the drawer front.
4. Remove the screws that secure the drawer front to the drawer box. Also remove the (2) drawer locking device by removing the (2) screws
that secure each locking device to the bottom front edge of the drawer box. Discard the existing drawer box.
5. Obtain the new wood tiered cutlery divider drawer (WTCD). Locate the locking devices & screws from Step 4. The locking devices should be
pushed against the inside of the drawer sides with the flange on the locking device overlapping the bottom edge of the drawer box front.
Attach each drawer locking device with (2) #6 x 5/8" phillips flat head screws.
6. Open the bag of screws & "Figure 8" shaped fasteners that were included with the WTCD. Secure a Figure 8 fastener on each side of the
drawer box front using the pre-drilled pilot hole as a locator. Note: The larger diameter portion of Figure 8 fastener should be oriented towards
the center of the drawer box with the counter sunk side visible and facing outward.
7. Once the (2) Figure 8 fasteners have been secured to the drawer box place the drawer box on the back of the drawer front from Step 4.
Align the bottom (2) corners of the drawer box with the pencil marks. Drill a 7/64" dia. X 3/8" deep pilot hole thru the middle of each fasterner
and into the back of the front. Be careful to not drill thru the drawer front. Secure the drawer box to the drawer front with the (2) flat head screws
using the remaining smaller diameter holes in the Figure 8 fasteners
WOOD TIERED CUTLERY DIVIDER DRAWER (WTCD) INSTALLATION INSTRUCTIONS
REV: A-3/18/10
S900113
using
the
remaining
smaller
diameter
holes
in
the
Figure
8
fasteners
.
8. Place the WTCD with drawer front attached into the cabinet by sliding the box onto the hardware until the hooks engage the holes
drilled in the back of the drawer box. You will hear a "click" when the drawer box and hardware is fully engaged. You may need to squeeze
the locking device releases and push back to ensure the hardware is engaged. The drawer box can be removed by squeezing the arms on
the locking devices and pulling forward. Once the drawer is installed the corners can be raised/lowered by up to 1/8" by sliding the vertical
adjustment lever forward/backward. Adjust as necessary to ensure the drawer front aligns with the adjacent cabinets.
Step 1 & 8 Step 6 Step 3 & 7
1
SQUEEZE TO
RELEASE
VERTICAL
ADJ. LEVER
LOCKING DEVICES
(bottom view)
FIGURE 8
WITH C-SINK
FACING
OUTWARD
FRONT OF WTCD
BOTTOM OF WTCD
BACK OF DRAWER FRONT PENCIL MARKS
FIGURE 8
FASTENER
REV: A-3/18/10
S900113