Use and Care Manual

Customer Service: 800-626-1126 | rev-a-shelf.com
2
FIG. 2
Pull frame out; locate the (2) plastic
tabs under frame and press to
engage into frame. See Fig. 3
STEP 2
STEP 3
#2
STEP 1
Place the back of the frame on top
of the slide assembly and push
back until the slide hooks engage
into the holes on the frame. Rotate
down to engage the posts on the
front of the slideset to the holes on
the bottom of the frame.
See Fig. 2
For Frameless or Shelf
Place slide assembly in cabinet,
center and set back 1” from front
of cabinet to the front of the
slide. Install (4) 8 x 5/8” truss head
screws into slots. See Fig.1
For Face Frame:
Place the slide assembly in cabinet,
center and set back 1” from the
front of cabinet. With a pencil,
mark the center of the (4) screw
holes. See Fig. 1A
Remove the slide assembly and
center the (4) spacers on the marks
from step one. Place the slideset
over the spacers. Install (4) 8 x 1”
wood screws into slots.
See Fig. 1B & 1C
FIG. 1 FIG. 1A
FIG. 3
FIG. 1B FIG. 1C
1” (25 mm)
1” (25 mm)