Use and Care Manual

ManualsBrandsRev-A-Shelf ManualsKitchen14 in. Wood Cabinet Pull Out Drawer with Soft Close

INSTALLATION INSTRUCTIONS: 4WDBSC - WOOD DRAWER PULLOUT

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

DRAWER PULLOUT

TOOLS REQUIRED:

15 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and

wipe parts dry.

I-4WDBSC-0820

Parts List

No. Description Qty

A Wood Frame 1

B Slideset 1

C #8 X 5/8” Truss Head Screw 4

D #8 X 1” Wood Screw 4

E Spacer 4

C. D. E.

For video instruction visit:

rev-a-shelf.com/videos

Summary of content (4 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 DRAWER PULLOUT TOOLS REQUIRED: #2 ESTIMATED ASSEMBLY TIME: 15 MIN CARE AND MAINTENANCE: Clean with a damp cloth and wipe parts dry. Parts List No. Description Qty A B C D E Wood Frame Slideset #8 X 5/8” Truss Head Screw #8 X 1” Wood Screw Spacer 1 1 4 4 4 A. B. C. D. E. For video instruction visit: rev-a-shelf.
PAGE 2
STEP 1 For Frameless or Shelf FIG. 1 FIG. 1A Place slide assembly in cabinet, center and set back 1” from front of cabinet to the front of the slide. Install (4) 8 x 5/8” truss head screws into slots. See Fig.1 For Face Frame: Place the slide assembly in cabinet, center and set back 1” from the front of cabinet. With a pencil, mark the center of the (4) screw holes. See Fig. 1A m) 1” (25 m m) 1” (25 m Remove the slide assembly and center the (4) spacers on the marks from step one.
PAGE 3
12400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 INSTRUCCIONES DE INSTALACIÓN / LES INSTRUCTIONS D’INSTALLATION EXTRACCIÓN DE CAJÓN DE MADERA / TIROIR COULISSANT EN BOIS Herramientas requeridas: Outils Requis: #2 Tiempo estimado de ensamblado Durée de l’installation: 15 MIN Cuidado/ Entretien: Limpie con un paño húmedo y seque las partes. Nettoyer avec un chiffon humide et essuyer pour sécher complètement. Lista de partes / Liste des pièces No. A B C D E A.
PAGE 4
PASO 1 / ÉTAPE 1 Para sin marco FIG. 1 FIG. 1A Coloque el conjunto deslizante en el gabinete, centre y retroceda 1” desde la parte delantera del gabinete hasta la parte delantera de la corredera. Instale (4) tornillos de cabeza truss de 8 x 5/8” en las ranuras. Ver Fig. 1 Para estante: Coloque el conjunto deslizante en el gabinete, centre y retroceda 1” desde la parte delantera del gabinete. Con un lápiz, marque el centro de los (4) agujeros de tornillo. Ver Fig.