Installation Guide

Customer Service: 800-626-1126 | rev-a-shelf.com
4
FIGURE 9
Retainer Clip
RE-ENGAGE UNIT
Re-engage the unit into each of
the cabinet members, ensuring the
slides are aligned properly
(See Fig 8). Once engaged, fully
cycle the unit a few times to ensure
proper slide operation.
STEP 8
Attach each side mounting bracket
to the inside of the face frame
using the (6) provided #6 x 5/8”
at head screws (See Fig 7).
STEP 7
Re-install the gas spring while
making sure that the gas reservoir
is attached to the top stud as
shown in Fig 9. Make sure to install
both of the retainer clips into each
of the stud caps.
STEP 9
At this time, proceed to page 8
and continue your installation.
STEP 10
FIGURE 7
FIGURE 8
#2