Installation Guide

ManualsBrandsRev-A-Shelf ManualsPull Out Trash Cans50-Quart Plastic Soft Close Pull Out Trash Can

INSTALLATION INSTRUCTIONS: 4WCDM SERIES BOTTOM MOUNT WASTE CONTAINER

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

4WCDM SERIES BOTTOM MOUNT WASTE CONTAINER

TOOLS REQUIRED:

45 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and

wipe parts dry.

I-4WCDM-SC-0217

Parts List

No. Description Qty

1 Frame 1

2 Slide Triggers w/ Screws 2

3 Door Mount Screws 6

4 Slide Set w/ Template 1

5 Waste Container(s) 1-2

6 Lid 1

Summary of content (4 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 4WCDM SERIES BOTTOM MOUNT WASTE CONTAINER TOOLS REQUIRED: #2 1 16 #2 ESTIMATED ASSEMBLY TIME: 45 MIN No. Parts List Description Qty 1 Frame 1 CARE AND MAINTENANCE: 2 Slide Triggers w/ Screws 2 Clean with a damp cloth and wipe parts dry.
PAGE 2
INSTALLING THE SLIDES STEP 1 FIGURE 1 Use the Blum template to install slides to cabinet floor (See Fig 1) MOVENTO ATTACHING TRIGGERS STEP 2 Install the Blum locking devices to the underside front corners of the wood frame with supplied screws (See Fig 2). FIGURE 2 PRE-DRILLED HOLES DOOR MOUNT BRACKET ORIENTATION STEP 3 Loosen the bolts and switch door mount brackets from the position they were shipped in to the normal position.
PAGE 3
STEP 4 FIGURE 4 Place frame on slides and push back until slides engage (See Fig 4). When the slides are engaged, you will hear a distinctive “click” sound. PUSH UNTIL YOU HEAR A ”CLICK” DOOR MOUNTING STEP 5 FIGURE 5A Refer to Figure 5A for the proper door mounting measurements. 1) Make sure that your unit is securely installed into your cabinet. Remove the cabinet door and hinges to begin to mount your door.
PAGE 4
DOOR MOUNT W/ DOUBLE SIDED TAPE STEP 6 Refer to Figure 6 for tape position locations. Approximate the door position in order to be centered both horizontally and vertically and press against the tape. Attach the brackets to the door with the provided #6 x 1/2” screws. NOTE: While this method is quicker and easier than the previous method for door installation, it also comes with the drawback that you cannot horizontally adjust your door once brackets are attached.