Installation Instructions

3INSTALLATION INSTRUCTIONS: 4WC DOUBLE 30 QT WASTE CONTAINER WITH BLUM® SOFT-CLOSE
Refer to Figure 5 to determine
door mounting hole locations.
Transfer these dimensions to your
door from the bottom and mark
the hole locations. Pre-drill these
holes on the back side of your
cabinet door, making sure NOT to
drill through the door.
Re-install door mount brackets.
NOTE: Spacers may be needed
in between the upright and
door mount bracket to reach
the thick portion of the door
(See Figure 4).
STEP 4
DOOR MOUNT
INSTALLATION
STEP 5
FIG. 4
FIG. 5
3
32
1) Make sure that your unit is securely installed into your cabinet. Remove the cabinet door and
hinges to begin to mount your door.
2) Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
Note: Depending on your particular basket design L-Bracket will mount on either inside or
outside of wire.
3a) Attach the door brackets to the outside of the L-brackets using the (4) provided screws.
Inside wire shown
4)
Aplique cinta de doble lado a los soportes de la puerta. Sujete la puerta del gabinete a los
soportes mientras trata de mantener la puerta a nivel. No se preocupe si la puerta se mueve un
poco, esto puede ser ajustado. La cinta de doble lado sujetara la puerta en su lugar mientras usted
atornilla los soportes a la puerta del gabinete.
Mettez du ruban adhésif double sur les supports de porte. Fixez la porte de l’armoire aux
supports tout en essayant de maintenir la porte à niveau. Ne vous inquiétez pas si elle n’est pas
tout à fait à niveau, tout cela peut être ajusté. Le ruban adhésif double tiendra la porte en place
pendant que vous vissez les supports sur la porte de l’armoire.
3c) Se proveen espaciadores de plástico si es que los soportes de la puerta necesitan ser extendi-
dos para alcanzar la porción gruesa de la puerta.
Des espaceurs en plastique sont fournis si les supports de porte doivent être étendus plus loin
pour atteindre la partie épaisse de la porte.
3b) Cada puerta de gabinete es diferente, pero asegúrese de que el soporte de la puerta se alinea
con la porción gruesa de la puerta del gabinete. Esto asegurará que los tornillos no se atraviesen ni
dañen su puerta.
Chaque porte d’armoire est diérente, mais assurez-vous que le support de porte s’aligne avec
la partie épaisse de la porte de l’armoire. Cela permettra d’assurer que les vis ne vont pas passer
à travers et endommager votre porte.
Measure Opening Height ________
Measure Door Height ________
Height Difference ________
Divide Difference by 2 ________
Mark screw locations on
your door and pre-drill.
Be careful not to drill
through the cabinet door.
If your door is larger than cabinet opening,
add the divided difference you found in
step 2 to the measurements in step 1. If
your door is smaller, subtract the divided
difference from the measurements in step 1.
Top Measurement ________
Bottom Measurement ________
Measure from frame to top bracket slot ________
Measure from frame to bottom bracket slot ________
2.
3.
Remove the door mount
brackets and screw to inside of
cabinet door with #6 x 1/2” at
head screws.
NOTE: Line up door mount
bracket to cabinet door by
aligning door mount bracket
with the marks you made in step
5 (See Figure 6).
STEP 6
FIG. 6