Installation Instructions

3
Face frame only:
Attach the rear Blum brackets on
the back of the cabinet using (2)
#8 x 5/8” wood screws for each
bracket.
Note: Place (1) screw in one
of the top row corners and (1)
screw in the bottom row corners
on the opposite side (See Figure D).
INSTALLATION INSTRUCTIONS: MAPLE DRAWER SYSTEM
If you have 30” or 36” combination
drawer box, either face frame or
frameless, refer to the Blum lateral
stabilizer bar instruction sheet
included in the stabilizer
bar kit.
STEP 4
STEP 5
13/16”
(21 mm)
3/32”
(2 mm)
1-1/4”
(32 mm)
5/8”
(16 mm)
1-1/32”
(26 mm)
15/32”
(11.6 mm)
9/16”
(14 mm)
FIG. C
Face frame:
Make sure both slides are set back
1/8” from the edge of the face frame
while being supported by their rear
brackets. Attach both slides to the
face frame by using (2) #6 x 1/2” for
each slide (See Fig D-1 & D-2).
Frameless:
Attach both the left and right Blum
slides to the frameless cabinet
using (3) #8 x 5/8” wood screws
for each side. Make sure the front
of the slide is set back 1/8” from the
front edge of the cabinet
(See Fig E-1 & E-2).
STEP 6
FIG. D-1
FIG. E-1
FIG. D-2
FIG. E-2
Screws
1/8”
1/8”
Screws