Installation Instructions

INSTALLATION INSTRUCTIONS: VANITY SIDE MOUNT U-SHAPED PULLOUT
FIG. F
FIG. E
FIG. D
FIG. G
Cabinet Wall
Cabinet Wall
Slide
Slide
Side Mount Bracket
from Step 1.
Side Mount Bracket
from Step 1.
Side Mount Bracket
from Step 4.
Side Mount Bracket
from Step 4.
Door
ICW
Overhead Cabinet View
I-486VSM-1217
Measure the inside cabinet width
(ICW) and subtract 25 (See Figure
D). Take that number and divide
by 2, this is dimension “A”.
“A” = (ICW – 25) ÷ 2 = ____
STEP 5
Place left slide with side mount
bracket from Step 1 on top of left
side mount bracket from Step 4.
Insert (2) #8-32 at head screws
and (2) lock nuts into the slots
then measure from cabinet wall to
the side mount bracket’s vertical
wall until it is dimension “A” and
tighten screws/lock nuts (See
Figure E).
NOTE: The top side mount
bracket can be ipped for a
lower shelf height (See Figure F).
STEP 6
Adjust the back bracket to lay
ush against the cabinet rear wall
and attach with (2) #8 x 5/8” truss
head screws (See Figure G).
Repeat steps 6-7 for right side.
STEP 7