Template

Screw and Pilot Hole
Location (4) Places
Center line of Cabinet Opening
Front edge of paper
to front of cabinet
(or front of face frame)
Attaching slide to cabinet
1) Using the mounting template locations, pre drill 4 holes using a 3/32”
drill bit.
2)Removetemplateandattachtheslideassemblytotheoorofthe
cabinetusing(4)#8x¾”deepthreadscrewsprovided.
3) With the slides in the fully closed position, place the frame on the slides
and push back until you feel the slides engage the locking devices (you
will hear a click sound). Fully cycle the frame a few times.
Attaching the cabinet door
1) Loosenthe(4)locknuts(3/8”wrench)insidethefrontwalloftheunit.
(See Fig 1)
2) Pull the Adjustable Door Mounting Brackets to ensure that you are
mounting to the “thick” portion of the cabinet door. (Front of pull out
should line up with front of face frame).
3) Usethe(4)#6x½”atheadscrewsprovidedtoattachthedoortothe
pullout unit.
4) Ifthedoorneedstobetiltedtolayushagainstthefaceframe,loosen
the8mmnutsandturnthe“T-Nut”screwssothatitpushesagainstthe
metal bracket. Each corner can be adjusted independently. (Note: It
is recommended that door bumpers be used on each corner to ensure
quiet operation)
Install rub bushings using enclosed kit and instructions (Note: Chassis may need to be
removed for proper installation)
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
5” SOFT-CLOSE PULLOUT WITH BLUM TANDEM SLIDES WITH BLUMOTION
TOOLS REQUIRED:
30 MIN
ESTIMATED ASSEMBLY TIME:
CARE AND MAINTENANCE:
Clean with a damp cloth and
wipe parts dry.
PARTS LIST
- Frame/Slide assembly
- (4) #6 x ½” at head screw
- (4) #8 x ¾” deep thread pan
head screw
- Template
- Rub Bushing Kit
3
32
Fold Template along this edge to t
cabinet opening.
Fig 1
T-Nut Screw for
Tilt Adjustment
Lock Nut
T-448SC-1219