Assembly Instructions

Front edge of paper to front of cabinet
(or front of face frame)
Center Line of Cabinet Opening
TOOLS REQUIRED:
30 MIN
ESTIMATED ASSEMBLY TIME:
CARE AND MAINTENANCE:
Clean with a damp cloth and
wipe parts dry.
PARTS LIST
- Frame/Slide Assembly
- (4) #6 x 1/2” Flat Head Screws
- (4) #8 x 3/4” Deep Thread
Pan Head Screws
- Template
- Adjustable Rub Bushing Kit
3
32
T-448SC1114-0617
Attaching slide to cabinet
1) Use the hole locations on the template to pre-drill (4) holes using a 3/32” drill bit.
2)Removetemplateandattachtheslideassemblytotheoorofthecabinetusing(4)#8x3/4”deepthreadpanheadscrewsprovided.
3) With the slides in the fully closed position, place the frame on the slides and push back until you feel the slides engage the locking devices (you will hear a click
sound). Fully cycle the unit a few times.
Attaching the cabinet door
1) Loosenthe(4)locknuts(3/8”wrench)insidethefrontwalloftheunit(SeeFig.1).
2) Position the Adjustable Door Mounting Brackets to ensure that you are mounting to the “thick” portion of the cabinet door (Front of pullout should line up with
front of face frame).
3) Usethe(4)#6x1/2”atheadscrewsprovidedtoattachthedoortothepulloutunit.
4) Ifthedoorneedstobeadjustedtolayushagainstthefaceframe,loosenthe8mmlocknutandturnthe“T-Nut”screw.Re-tighten8mmlocknut.Eachcorner
can be adjusted independently. (Note: It is recommended that door bumpers be used on each corner to ensure quiet operation)
Install rub bushings using enclosed kit and instructions (Note: Chassis may need to be removed for proper installation)
Hole Locations
Fold template along this edge to t
cabinet opening.
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
14” SOFT-CLOSE PULLOUT WITH BLUM TANDEM SLIDES WITH BLUMOTION
Fig. 1
T-Nut Screw for
Tilt Adjustment
Lock Nut
3
8