Installation Sheet

Customer Service: 800-626-1126 | rev-a-shelf.com
2
STEP 2
STEP 1
STEP 3
Using the provided template,
mount the bottom of the slide set
to the oor of the cabinet using (4)
#8 x 3/4” deep thread screws.
Mount the sides of the slide set
to the side (Almond Plate) of the
cabinet using (2) #8 x 1/2”screws
(See Figure 2).
Place unit on its side and press
orange release levers to disengage
slides and pull slides off the unit.
(See Figure 1).
Turn unit onto its side and pull
chain through. Remove chain end
piece and install on cabinet oor
using template. Re-attach the
chain to the end piece end piece
by pushing rmly together (See
Figure 3).
BACK OF CABINET
BACK OF CABINET
Cabinet oor
Back of
faceframe
.75”
(19.1mm)
15.96”
(405.5mm)
8.64”
(219.4mm)
.51” (13mm)
Front edge of strap
to back of faceframe
Use a small athead
screwdriver to
carefully pry at this
location to separate
end from wire chain
Install this piece on to
the oor of the cabinet
using the template
Release levers
Chain
FRONT OF CABINET
FRONT OF CABINET
SIDE VIEW
Figure 2
Figure 1
Figure 3
TOP VIEW
3.14”
(79.7mm)
Almond Plate