Installation Sheet

ManualsBrandsRev-A-Shelf ManualsCabinet Hardware9-1/4 Inch Pull Out Vanity Cabinet Grooming Organizer with Electrical Outlets and Soft Close

INSTALLATION INSTRUCTIONS: VANITY OUTLET GROOMING ORGANIZER

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

VANITY OUTLET GROOMING ORGANIZER

TOOLS REQUIRED:

25 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and

wipe parts dry.

I-445VBOSC-0120

Parts List

No. Description Qty

A Base unit w/ bins 1

B #8 x 3/4” Slideset mounting screws 10

C #8 x 1/2” Slideset side mounting screws 2

D #6 x 1/2” Flat head screws 12

C. D.

WATCH TUTORIALS OF OUR

PRODUCTS BEING INSTALLED

WWW.REV-A-SHELF.COM/VIDEOS

SAFETY INSTRUCTIONS

Customer’s responsibility:

• Install 120v outlet in rear of cabinet within 10” of bottom of unit.

• Do not overload outlet.

• Wood is combustible. Do not put/leave hot items in the bottom of the unit. Only place hot items in

the two silver cans.

• Customer is responsible for wiring and connecting plug in cabinet.

• Do not leave hot items unattended while on/in the unit.

• Turn off hot items not in use in the unit.

Product intention of use:

• Product is intended for vanity electronic device usage.

• Overall safety of this product is determined by its end use.

Important safety instructions. Caution: To reduce risk of re or electronic shock or injury to persons:

• Not intended to be used in damp locations. Dry locations only.

• Not intended for long term storage. Items should be monitored.

• Unit should be removed and inspected at least twice a year.

• Route and secure cords so that they will not be pinched or damaged when unit is closed.

• A licensed electrician should be consulted for wiring through ceiling, softs or walls. All wiring must

follow NEC regulations.

• Do not alter plug.

•Wood is combustible. Do not put or leave hot items in the bottom of the unit.

(If in doubt … leave it out)

• Do not store combustibles in unit (i.e. aerosols).

Summary of content (8 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 VANITY OUTLET GROOMING ORGANIZER Parts List TOOLS REQUIRED: #2 3 32 No. Description Qty A B C D Base unit w/ bins #8 x 3/4” Slideset mounting screws #8 x 1/2” Slideset side mounting screws #6 x 1/2” Flat head screws 1 10 2 12 A. B. C. D. ESTIMATED ASSEMBLY TIME: 25 MIN CARE AND MAINTENANCE: Clean with a damp cloth and wipe parts dry.
PAGE 2
STEP 1 Place unit on its side and press orange release levers to disengage slides and pull slides off the unit. (See Figure 1). Figure 1 Release levers STEP 2 Using the provided template, mount the bottom of the slide set to the floor of the cabinet using (4) #8 x 3/4” deep thread screws. Figure 2 SIDE VIEW BACK OF CABINET TOP VIEW FRONT OF CABINET 8.64” (219.4mm) Mount the sides of the slide set to the side (Almond Plate) of the cabinet using (2) #8 x 1/2”screws (See Figure 2). 3.14” (79.
PAGE 3
STEP 4 Attach the base unit to the slide set by releasing the Blum triggers and sliding the unit on to the slide base (See Figure 4). Figure 4 Note: You will hear a distinct “click” when properly engaged. DOOR MOUNT INSTRUCTIONS Figure 6 Once the product is installed you want to install the cabinet door for easy access. Make sure the door brackets are lined up with the thick portion of the cabinet door (See Fig. 6).
PAGE 4
STEP 7 FIG. 9 Measure the cabinet opening and then measure the door size. Take the difference of these two numbers and divide it by 2. This number is the door overlay or inset gap (See Figure 9). Door size Cabinet opening STEP 8 If the door is larger than the opening ADD the door overlay to the Step 1 dimensions. Difference ÷ 2 (overlay or inset) Difference FIG. 10 If the door is smaller than the opening SUBTRACT the inset gap from the Step 1 dimensions.
PAGE 5
12400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 INSTRUCCIONES DE INSTALACIÓN / LES INSTRUCTIONS D’INSTALLATION TOCADOR ORGANIZADOR PARA EL CUIDADO PERSONAL ORGANISATEUR DE PRISES DE VANITÉ POUR SOINS DE BEAUTÉ Herramientas requeridas: Outils Requis: #2 3 32 Lista de partes / Liste des pièces Descripción / Description No. Qty A B Mueble base con cajones / Unité de base avec bacs Tornillos de montaje del juego de correderas n.
PAGE 6
PASO 1 / ÉTAPE 1 Figure 1 Coloque la unidad de costado y presione las palancas naranjas de liberación para desenganchar las guías y retirarlas de la unidad. (Ver Figura 1). Placer l’unité sur le côté et appuyer sur les leviers de dégagement orange pour désengager les glissières et les tirer pour les retirer de l’unité. (Voir la Figure 1).
PAGE 7
PASO 4 / ÉTAPE 4 Coloque la unidad base en el juego de correderas liberando los activadores de Blum y deslizando la unidad en la base de las correderas (véase la figura 4). Figure 4 Nota: Escuchará un “clic” claro cuando esté bien acoplada. Fixer l’unité de base à l’ensemble de glissières en libérant les déclencheurs Blum et en glissant l’unité sur la base de la glissière. (Voir la Figure 4). Remarque : Vous entendrez un « clic » distinct lorsque les deux pièces sont bien enclenchées.
PAGE 8
PASO 7 / ÉTAPE 7 FIG. 9 Mida la apertura del gabinete y luego mida el tamaño de la puerta. Tome la diferencia de estos dos números y divídala por dos. Este número es la puerta sobrepuesta o el espacio del recuadro (ver la figura C). Apertura del gabinete Tamaño de la puerta Ouverture de l’armoire Mesurez l’ouverture de votre armoire, puis mesurez la taille de votre porte. Prenez la différence de ces deux nombres et divisez-la par 2.