Installation Sheet

1) To install in from the back of the cabinet,
rst remove the wood shipping strap from the
front of the unit, slide unit In thru the back
of the cabinet and center it. Screw to the top
and bottom. Depending on the Height of your
cabinet a spacer may need to be made to t the
gap between the top of the cabinet and the top
of the ller.
I-438-0614-TRI
TOOLS REQUIRED:
ESTIMATED ASSEMBLY
TIME:
20 MIN
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY.
INSTALLATION
INSTRUCTIONS
438 Base Cabinet Filler
[phone]
www.rev-a-shelf.com
OPTION 1
INSTALL FROM
THE BACK OF
THE CABINET
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
NOTE
Press release lever up or
down pull frame out and
remove before installation.
Reinstall after attaching the
frame inside of the cabinet.
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
1) To install the ller into a face frame cab-
inet you will need to cut material o of the
bottom of the unit. (See detail A&B below)
cut to your desired height depending on
your opening to be inserted through the face
frame and into the cabinet.
2) Center unit inside the cabinet (hint: you
may want to cut 2 blocks, 1 on each side of
rear inside of the cabinet to help hold the
ller centered) and screw to the top and bot-
tom. You will need to make a spacer to ll the
space between the top of inside the cabinet
and ller. Remove the wood shipping strap
from the front of the unit.
OPTION 2
INSTALL FROM
THE FRONT OF
THE CABINET