Installation Sheet

Customer Service: 800-626-1126 | rev-a-shelf.com
4
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
Refer to Figure K for the
following steps:
Step 1
Mark the center of your
cabinet, then slide the chassis
into the back of the cabinet so
it is centered in the cabinet.
Step 2
Screw through the top and
bottom of the chassis to secure
to the cabinet
Step 3
Insert the pullout into the
chassis.
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
STEP 2
CHASSIS
STEP 1
PULLOUT
FIGURE K
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
STEP 3
SPACER
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
NOTE: A spacer is needed to
t the gap between the top
of the cabinet and the top of
the frame. (See Fig I)
NOTE: You may want to cut
place 2 blocks, 1 on each side
of the chassis to help hold it
centered in the cabinet. To
cut the wooden blocks to the
correct dimension, measure
the inside cabinet width,
subtract the width of the
chassis, and divide by 2
(See Fig J).
FIGURE I
SPACER
(NOT INCLUDED)
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
FIGURE J
DETAIL A
DETAIL B
CUT DOWN TO MINIMUM
HEIGHT OF 26.38
SEE DETAIL A
OVERALL HEIGHT 27.31
SEE DETAIL B
BLOCKS
(NOT INCLUDED)