Installation Guide

432 Series Filler
Pull-Out Instructions
Step 1. Measure scribe rail thickness and length
per your specic cabinetry. See g 1
Step 2. Install scribe rails to
ller pull-outs using small
nish nails or brads. See g 2
Note: align scribe rails with
front edge of ller pull-out.
Align scribe rail to upper
section of base cabinet lower
mounting strap or lower
section of wall cabinet lower
mounting strap. See gs. 3a–b
Figure 1
Figure 2
Figure 3a
Wall Cabinet
Figure 3b
Base Cabinet
Top Scribe Rail is nailed to
bottom edge of top section
Bottom Scribe Rail is nailed
to edge of bottom section
Top Scribe Rail is
nailed to edge of top
section
Bottom Scribe Rail is
nailed to edge of
bottom section
I-432 6-05