Instructions / Assembly

Customer Service: 800-626-1126 | rev-a-shelf.com
2
Position the tray on the clips and
gently press downward to engage
the spring lock. This completes the
installation of your Door Storage
Utility Tray.
STEP 2
STEP 3
FIGURE 1
FIGURE 3
STEP 1
Remove the tray from the clips
if you haven’t already. Mark the
bottom locations and then swing
the clip to the side to pre-drill
the locations marked (See Fig.
2). Once you have the bottom
location pre-drilled, repeat the end
of step 1.
Note: Use plastic screw anchor or
#6-32 toggle bolts (not provided)
when installing Screw-In Clips on
wallboard, plaster or very thin
material.
Snap in one end of the clip into the
slot at each end of the tray. Hold
the shelf in place while marking the
upper screw locations using the
upper holes in each clip. Pre-drill
and screw in your clip in the (2) top
locations using (2) #6 x 1/2” screws
(See Fig. 1).
Note: Before marking the top
hole location on the clip, ensure
tray is level.
FIGURE 2
3
32
3
32