Instructions / Assembly

ManualsBrandsRev-A-Shelf ManualsKitchen Appliance4 in. H x 20 in. W x 4 in. D Single Cabinet Door Mount Wood Storage Tray

INSTALLATION INSTRUCTIONS: DOOR STORAGE UTILITY TRAYS

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

DOOR STORAGE UTILITY TRAYS

TOOLS REQUIRED:

15 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and

wipe parts dry.

I-46DSUT-1120

Parts List

No. Description Qty

A Storage Unit Tray* 1

B White Screw Clips 2

C #6 X 1/2” Oval Head Screws 4

WATCH TUTORIALS OF OUR

PRODUCTS BEING INSTALLED

WWW.REV-A-SHELF.COM/VIDEOS

* wood or polymer

Summary of content (4 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 DOOR STORAGE UTILITY TRAYS TOOLS REQUIRED: #2 3 32 ESTIMATED ASSEMBLY TIME: 15 MIN CARE AND MAINTENANCE: Clean with a damp cloth and wipe parts dry. Parts List No. Description Qty A B C Storage Unit Tray* White Screw Clips #6 X 1/2” Oval Head Screws 1 2 4 * wood or polymer A. B. C. WATCH TUTORIALS OF OUR PRODUCTS BEING INSTALLED WWW.REV-A-SHELF.
PAGE 2
FIGURE 1 STEP 1 Snap in one end of the clip into the slot at each end of the tray. Hold the shelf in place while marking the upper screw locations using the upper holes in each clip. Pre-drill and screw in your clip in the (2) top locations using (2) #6 x 1/2” screws (See Fig. 1). Note: Before marking the top hole location on the clip, ensure tray is level. 3 32 FIGURE 2 STEP 2 Remove the tray from the clips if you haven’t already.
PAGE 3
12400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 BANDEJAS DE ALMACENAMIENTO PARA PUERTA PLATEAU DE RANGEMENT UTILITAIRE POUR PORTE Herramientas requeridas: Outils Requis: #2 3 32 Tiempo estimado de ensamblado Durée de l’installation: 15 MIN Cuidado/ Entretien: Limpie con un paño húmedo y seque las partes. Nettoyer avec un chiffon humide et essuyer pour sécher complètement. Lista de partes / Liste des pièces Descripción / Description No.
PAGE 4
PASO 1 / ÉTAPE 1 FIG. 1 Introduzca presionando un extremo del sujetador en la ranura de cada extremo de la bandeja. Sostenga el estante en el lugar indicado mientras marca la ubicación de los tornillos superiores utilizando los huecos superiores de cada sujetador. Marque con el taladro y atornille los sujetadores con rosca en las dos ubicaciones superiores utilizando los 2 tornillos nro. 6 de 1/2”. (Ver Fig. 1). Enclenchez une extrémité de la pince dans la fente à chaque extrémité du plateau.