User manual

Returnstar Interactive Technology Group Co., Ltd.
8
Chapter 3 How to Install IQBoard
3.1 Mount Whiteboard
3.1.1 For Product with an “M” in Its Hardware SN
In case your product has an “M” in its hardware SN, you can select wall mounting.
Parts list
Picture
Name
Quantity
Screw
4
Wall Anchor
2
Safety Bracket
2
Anchor Bolt
2
Wall Mounting Bracket
(already mounted on the
backboard)
2
Installation steps
Step 1. Determine the installation height of the Anchor Bolt (190cm above floor), then
measure the horizontal distance (70cm±3mm usually) of the 2 holes on the Wall
Mounting Brackets according to the location of the whiteboard. (Note: You’d better
take the actual horizontal distance of the 2 holes on the backboard as standard.) Drill
a hole at both ends, then screw the 2 Anchor Bolts into the holes and leave 4mm
clearance between bolt head and nut (as shown in the figure below).