User manual

3. Do one of the followings:
If you use pen or finger, follow the on-screen instructions, press the center of
each cross accurately with pen tip or finger tip.
If you use electronic pointer, follow the on-screen instructions, press the center of
each cross accurately with pointer tip and press the button on the pointer body.
Your whiteboard is now oriented.
6.2 Setup Hotkey
At the first time you use the whiteboard with soft hotkeys, you need to set these hotkeys.
Step 1. Select “Start > Programs > IQBoard ET & PS Drivers >Hotkey setting” to enter the
setting window, as follows
Step 2. Follow the indication on screen, click relevant hotkey in sequence. After the setting
is completed, you can use these hotkeys.
Prompt:
1. If you did not locate the accurate central point or clicked the wrong point, or the next
fixed point appeared without press, please press “ESC” on the keyboard to exit this
orientation and re-orient. Otherwise you can’t operate the whiteboard accurately.
2. Please make your electronic pen or writing pen (finger) upright when orienting.
3. In case the relative position of the whiteboard and projector is changed, or the driver or
the monitor resolution is altered, please re-orient.