User Manual

ManualsBrandsRetsch ManualsEquipmentPM GrindControl

Wireless Grinding Jar Cover

• Unscrew the antenna (4).

• Remove the two black caps from the venting holes (9).

• Remove the three screws (13) on the pre-assembled standard cover

baseplate and lift the plate up from the cover housing.

• Place the cover baseplate with the venting holes (12) in front of you with the

recess for the filter fleece (8) pointing upwards.

• Caution! When inserting the two de-aerating tubes (14), the surface

with which the tubes are fitted (flat) (10) must point downwards. After

tightening, this flat fits on the cover baseplate.

Fig. 44: Position of the de-aerating tubes

• Screw the two de-aerating tubes (14), as described, from the top downwards

into the cover baseplate (12) and tighten it with a 13-mm open-jaw wrench.

• Before assembly, check the state and the correct position of the seals and

the filter fleece.

• Now, insert the cover baseplate with the de-aerating tubes mounted on it into

the cover housing; when doing so, pay attention to the position of the filter

fleece (11).

• Next, tighten the cover baseplate with the three screws (13).

• Screw the two de-aerating valves (2) into the venting holes (9) and tighten

them with a 13-mm open-jaw wrench.

• Screw the antenna (4) onto the grinding jar cover.

Pos: 8.18 /00020 BDA Softwar e/20005 PMGC K apitelsammlung/Ü berschrift en/1.1 Übersc hriften/11 Filter vlies Wechsel @ 0 \mod_1209 389799774_9.d oc @ 742 @ @ 1

6.8 Changing the Filter Fleece

Pos: 8.19 /00020 BDA Softwar e/20005 PMGC K apitelsammlung/F unk Mahlbec herdeckel/Mod ul Wechsel des Fil tervlies es @ 0\mod_12 14313335584_9.d oc @ 1774 @ @ 1

Depending on the application and the period of use, it may be necessary to replace

the filter fleece that is located in the grinding jar cover.

Replace the filter fleece if it is very dirty.

6.9 Replacing the Filter Fleece When Using the Standard Cover Baseplate

Tools required:

Hexagon socket screw key 2.5 mm

• Unscrew the antenna (4).

• Remove the three screws (13), on the pre-assembled standard cover

baseplate and lift the plate up from the cover housing.