User guide

Operating the machine

This may then result in damage to the mechanical components.

• Using the knob (Dk), set the feed speed to a low level.

• Fill the feed hopper (A) with material.

• Check the position of the DR100 via the sample inlet on the ZM200.

• Start the ZM200.

Communication takes place between the ZM200 and DR 100, and this can take a

few seconds:

The DR 100 conveys the feed product to the ZM200.

• Slowly turn the knob (Dk) higher until the desired feed speed has been

reached.

As soon as an overload to the ZM200 is indicated, the ZM200 automatically

reduces the feed speed of the DR 100.

5.10.2 Interface to the PT100 / PT200

The device can be connected to the Retsch devices PT100 and PT200 using the

interface (I). The appropriate interface cable (Im) should be used for this.

• Set the operating mode selector switch (H) to Standard.

Fig. 22: Interface cable PT100 / PT200

Fig. 23: Interface on the PT100