User guide

Operating the machine

5.10.1 Interface to the ZM200

Fig. 19: Connecting the interface

The device can be connected to the RETSCH ZM200 interface (Z) using the

interface (I). The appropriate interface cable (Ik) should be used for this.

Fig. 20: Interface cable ZM200

Fig. 21: Interface on the ZM200

An overload to the ZM200 can be prevented by using the interface. As soon as an

overload to the ZM200 is indicated, the ZM200 automatically reduces the feed

speed of the DR 100.

• Connect both devices to the electricity supply.

• Connect interface (I) to the DR100 using interface (Z) on the ZM200.

• Set the operating mode selector switch (H) to standard.

NOTE

Set the DR100 feed speed to a low level when starting the ZM200. Otherwise the

ZM200 will be overloaded on starting and will no longer be able to reduce the feed.