User guide

Operating the machine
27
Fig. 18: Layer height
By twisting and sliding vertically, the hopper support makes it possible to place the
feed hopper in the correct position.
• Unscrew the fixing screw on the hopper support (E).
Set the desired layer height (Sh) between the bottom edge of the feed hopper (A)
and the base of the vibrating chute (C).
• To do this slide the hopper holder upwards or downwards as required.
• Tighten the locking screw on the hopper support (E).
NOTE
The layer height between the bottom edge of the feed hopper and the base of the
vibrating chute depends on the particle size of the feed material to be used.
The layer height should be at least 3 x greater than the maximum particle size of
the feed material.
The scale of the stand bar (G) is only intended as orientation aid for the set layer
height. It is not possible to directly read off the actual layer height set.
Pos: 9.24 /00005 Ü berschriften/ 1.1 Überschrifte n/1.1 Überschrift en BDA/11 Sch nittstellenverbi ndung herstelle n @ 3\mod_13 03201613915 _9.doc @ 252 10 @ 2 @ 1
5.10 Creating interface connection
Pos: 9.25 /00010 Bedienungsa nleitungen Kapitels ammlungen/DR 100_2012/0 007 DR100_20 12 Bedienung/0 080 DR100 Mo dul Schnittstelle nverbindung @ 4\mod_133 2148395095_ 9.doc @ 27043 @ 33 @ 1
Sh
A
C