Owner's Manual

13
STEP 5: FINISH THE INSTALLATION
The RetroSound
®
/DJXQDLVDXQLYHUVDOUDGLRVROXWLRQGHVLJQHGWRÀW
most classic vehicles. The display face of the Laguna measures 3.5
inches wide by 1.5 inches high, which will be smaller than the original
radio opening in most vehicles. We manufacture a wide variety of
PRXQWLQJEH]HOVDQGIDFHSODWHVWRÀOOWKHUHPDLQLQJVSDFHDQGÀQLVK
the installation.
IF USING A BEZEL3ODFHWKHEH]HORYHUWKHIDFHRIWKHUDGLRWKHQLQVWDOO
WKHDVVHPEOHGUDGLRIURPEHKLQGWKHGDVKXQWLOWKHEH]HODQGUDGLR
IDFHDUHÁXVKZLWKWKHIURQWRIWKHGDVKDQGWKHUDGLRVKDIWVSURWUXGH
through the shaft openings in the dash. Using the supplied washers and
shaft nuts (see “What’s In the Box” on page 4), mount the radio to the
dash, then secure it using the included back strap.
IF USING A FACEPLATE, slide the radio into the opening from behind
the dash, then align the faceplate over the radio shafts from the
IURQW7KHUDGLRIDFHVKRXOGDOLJQÁXVKZLWKWKHIDFHSODWHDQGWKH
shafts should not stick out too far. If it doesn’t look correct, revisit the
previous steps to adjust as necessary. Once the radio and faceplate
are in place, use the supplied washers and shaft nuts (see “What’s
In the Box” on page 4) to secure the faceplate to the dash and the
radio (DO NOT OVERTIGHTEN).
$ERYHH[DPSOHRIDEH]HO
Above: example of a faceplate
INSTALLATION INSTRUCTIONS