Owner's Manual

NOTE: This unit requires +12 volts to both the red and

yellow wires, otherwise it will not operate.

Locate the three wiring harnesses: Main Wiring Harness, Power

Wiring Harness and Speaker Wiring Harness (see “What’s in the

Box” on page 4). First connect the Main Wiring Harness to the back

of the radio. Then connect both the Power and Speaker Wiring

harnesses to the black female plug of the Main Wiring Harness.

After doing this, connect the bare wire ends of your power and

speaker wires to the appropriate power and speaker locations

in your vehicle (see Figure 5). Have your radio installed by a

SURIHVVLRQDOLIWKLVSDUWRIWKHLQVWDOOLVWRRGLIÀFXOWRUFRQWDFWXVLI

you have questions.

Installation Notes

• To prevent damage to the unit, do not connect the power

connector until you have completed the wiring process.

• This is a 12 volt negative-ground ONLY radio. If you

have a positive ground, or a 6-volt system, you need

to either convert to 12 volts or purchase a separate

inverter that would step up the voltage to 12 volts.

• Please note that the inverter must be rated at 10 amps

or higher in order for the radio to operate properly.

Rear AUX Input

The rear auxiliary input allows you to listen to any portable device

with standard 1/8” (3.5mm) headphone outputs. An example of an

external source would be a MP3 player, iPod

or iPhone

, portable

CD player or portable satellite radio receiver. To use this input,

the auxiliary cable must be routed to an accessible area during

installation.

INSTALLATION INSTRUCTIONS