Owner's Manual

Hermosa
Owner's
Manual
• Refer fuse replacement
to
qualified service personnel.
When the
fuse
blows
out,
eliminate the cause and have
it
replaced
with
the fuse
prescribed for this
unit
by a qualified service technician. Incorrect
replacement
of
the fuse may
lead
to
smoke, fire, and damage
to
the product.
• If
the
unit does not turn
on,
check
the
connections first.
Then check
whether
the fuse in
your
vehicle's fuse box
is
blown
and check the fuse
at
the unit's
wiring
harness.
Observe
these
warnings and precautions during
installation:
•
Do
not expose
the
unit
to
direct
sunlight
or
excessive heat.
Excessive
heat
will
raise the
interior
temperature
of
the unit, which may damage the unit.
•
Do
not
use
the
product
where
it
is
exposed
to
water, moisture, or dust.
Exposure
of
the
unit
to
water, moisture,
or
dust
may lead
to
smoke, fire,
or
other
damage
to
the
unit
and void
your
warranty. Make sure
that
the
unit
does
not
get
wet
in car washes
or
on
rainy days.
• Refer wiring and installation
to
qualified service personnel.
Installation
of
this
unit
requires special
skills and experience. For maximum safety, have
it
installed by
your
dealer. Retro
Manufacturing
is
not
liable
for
any
problems
resulting
from
your
installation
of
the unit. Please
be
sure
to
follow
our
instructions
carefully before
attempting
installation.
• Follow
the
instructions
to
install
and
wire
the product.
Not
following
the
instructions
to
properly install
and
wire
the
product
could
damage the
unit
or
cause an accident
or
fire.
•
Disconnect
the
lead
from
the
negative(-)
battery terminal before
installation.
Wiring
and i nsta
II
ation
with
the
negative (
-)
battery
term
ina
I
connected may cause
electrical
shock and
injury
due
to
a
short
circuit.
Some cars equipped
with
an
electrical
safety system have specific
procedures for
battery
terminal
disconnection.
FAILURE
TO
FOLLOW
THIS
PROCEDURE
MAY
LEAD
TO
THE
UNINTENDED
ACTIVATION
OF
THE
ELECTRICAL
SAFETY
SYSTEM
RESULTING
IN
DAMAGE
TO
THE
VEHICLE
AND
PERSONAL
INJURY
OR
DEATH.
•
Take care not
to
damage
the
leads.
Prevent
them
from
getting caught in
the
vehicle
chassis,
or
from
being damaged by screws
or
moving
parts,
such
as
seat
rails.
Do
not
scratch,
pull, bend
or
twist
the
leads.
Do
not
run
them
near heat sources
or
place heavy objects
on
them.
If
leads
must
be
routed around sharp metal
edges,
protect
the
leads
by
winding
them
with
vinyl
tape
or
similar
protection.
NOTE:
Cutting
the main wire harness,
RCA
Cables,
antenna
lead, auxiliary cables
or
USB
cable will void the
warranty
of
your
radio.
Copyright
2015
©
Retro Manufacturing,
LLC
}