Owner's Manual

STEP 1: Install the Radio Face

Plug the ribbon cable included with the Motor 2 body into

the radio face. After plugging in the face, attach it to

the body and tighten with the four radio face mounting

screws provided in the radio face box (the screws are very

small and are in the hardware bag with the shaft nuts).

The RetroSound

logo on the Motor 2 body

should be facing upwards. Take care to not

install the face to the body upside down.

NOTE: Optionally, the radio face can be mounted remotely up to

nine feet away from the Motor 2 body using an optional Face to

Body Extension Cable. In some installation applications, a bracket

can be used to mount the face to the body at an angle.

INSTALLATION INSTRUCTIONS

Figure 1 - Attach the Radio Face

Radio Face