Owner's Manual

EX-1 Battery Charger Owner's Manual
Operating Instructions (Continued)
EX-1 Charging Steps {detail)
The
Ex-1 battery charger features a 4 step charging process:
Step 1: Diagnostic Start Mode
Checks the battery voltage
to make sure battery connections are good and the
battery is in a stable
condition before beginning the charging process. Will start the
charging process
with a gentle "soft" charge.
Step
2: Primary Charge
Continues the Primary charging process, charges battery
to 90°/o capacity.
Step
3: Final Charge
Brings the charge level
to 1 00°/o. Once this threshold is reached, the battery charger
will deliver small amounts
of current to provide a safe, efficient charge and limit
battery gassing.
Step
4: Battery Maintain
Monitors the battery voltage
continuously to determine if a maintenance charge
should be initiated. If the terminal voltage falls below approximately 6.4V {6V) and
12.8V {12V), the charger will start the Battery Maintain cycle until voltage reaches
approximately 7.2V {6V) and 14.4V {12V) and then
will discontinue the charge cycle.
Maintain cycle
is repeated indefinitely to keep the battery at full charge, without
overcharging. Once connected and in this mode, the battery charger can be left
connected indefinitely.
Input Voltage AC:
Working Voltage AC:
Input Current:
Efficiency:
Power:
Charging Voltage:
Charging Current:
Back Current Drain:
Charger Type:
Type
of Batteries:
Battery Chemistries:
Battery Capacity:
Housing Protection:
Cooling:
Noise Level:
Dimensions {L x W x H):
Weight:
Approval:
120 VAC, 60Hz
110-130 VAC, 50-60Hz
1.2ARMS Max
82°/o Approx.
68W Max
7.2V/14.4V
3500mA
<5mA
4 Step, Fully Automatic, Switch-Mode
6V
& 12V Lead-Acid
Wet, Gel,
MF & AGM
12-70Ah, Maintains All Battery Sizes
IP65
Natural Convection
<50
dB
6.5 x 2.9 x 1.83 Inches
.53
Kg/1.17 Pounds
UL
for US and Canada