Owner's Manual

EX-1
Battery Charger Owner's
Manual
Operating
Instructions
00
00
0
12V
6V
AGM
STD
START
••
REVERSE
FAULT
POWER
CHARGING
FULL
0 0 0 0 0
Upon making a
proper
battery connection,
plug
the AC power cord
into
an AC
receptacle.
All
unit
LEOs will
light
momentarily, then
only
the LEOs corresponding
to
power
ON
and the default
charging settings
(12V,
AGM)
should
stay
lit.
The
charger is
now
in Standby Mode.
If
the Reverse Polarity Indicator LED
illuminates
along
with
and
audible "beep",
disconnect
from AC
power
supply
immediately
and determine the cause
of
the
alarm.
00
12V
6V
1.
00
AGM
STD
2.
0
START
3.
Choose a battery voltage
charge setting. The
default
setting is
the 12V mode,
which
will
apply
to
most
charging
applications.
To
charge in 6V mode, push the
SELECT
1 button
until
the
"6V"
LED is illuminated.
-
Choose a battery type setting. The default
setting is AGM
(corresponding
to
AGM and
Gel Cell style
batteries).
To
charge Standard and Maintenance Free acid batteries, push
SELECT
2 button
until
the
"STD" LED is
lit.
Press the
"START"
button, and both the
"START"
LED and
"CHARGING"
LED
will illuminate simultaneously.
Once the
this
process has started, the charger
will automatically
begin and complete the charging process
(Please
note
that
the
length
of
charging time may vary depending on the charging
condition
of
the battery). Note:
If
the FAULT LED
illuminates,
and
an
audible
beep is heard,
disconnect
immediately
from
AC
power
and determine the cause
of
the
alarm.
When the charging process is complete, the
"FULL"
LED
will illuminate.
This indicates
that
the
initial
charging
cycle is complete and the charger is
now
in
Maintenance Mode, and
will
resume charging as needed
to
keep
your
battery in
optimal
condition. When you are finished with the charging process,
disconnect
AC
power
cord
from
AC
outlet, then
disconnect
DC
leads
from
vehicle
ground
and
battery in the reverse sequence
of
the connection procedure.