Installation Manual

Pg. 8
For proper cover operation, ensure rails are
positioned correctly (must be parallel). See
step 6 & 7 in standard instructions).
Installation
Power – P
Motor – M
A. There is a white label wrapped with the letter “P” on it
to ensure proper connections are made. (Ensure the
connectors labeled P are securely connected. (Connectors
labeled “M” will come attached.)
B. Connect the wires to the battery and install a fuse in the
fuse holder. The RED wire (with the fuse holder) to the
POSITIVE post, and the BROWN wire will connect to the
NEGATIVE post.
Proceed with the RETRAX standard instructions on steps 1-8 Then refer back to this
page for connection of wiring. Disregard all references to ‘lock’ - Not applicable
for POWERTRAX.
NOTE: The electric cover has no lock assembly. Cover will not move out of the canister at this point of installation.
STEP 5: Connect the wiring harness to electronics box and battery
NOTE: The RETRAX cover has superior quality rail weather-strip seals. The weather-strip seals will have an initial
48 hour break in period. Please inform the end user to help the cover to the tailgate each time the cover is opened
for the first 48 hours or until it is able to close completely on its own.
Operation of the POWERTRAX
Hold to open
Hold to close
Press once to illuminate
light (auto shut off after 3
-5 minutes)
These surfaces must be level