Installation Manual

Pg. 21
Toyota Tundra 2007-up
w/ Deck Rail System
Check the parts shown here, this model has
different requirements than the standard
parts.
Follow standard instructions through step 3,
(pg. 2) then refer back to this guide
on how to install mounting hardware.
Remove and save the black plastic cap at the rear of
the Deck Rail track system on both sides of the truck.
Loosen and slide out the movable truck tie downs on
each side of the bed.
STEP 1: Remove plastic caps
Re-insert the tie down clamps on each side of the
bed, before inserting 2nd cleat.
After putting tie downs back into bed, insert 2nd
mounting cleat into track system on each side,
positioning it approximately 8” from tailgate.
Finish by re-inserting the black plastic cap into the
rear of the track system.
Insert 1 mounting cleat into the track system on each
side, position it about 15” from the front of the bed.
STEP 3: Re-insert tie downs and 2nd cleat
This photo shows how
the clamp will mount
to the rail. It is
important to be sure
that the threaded
hole on the cleat is
closest to the bottom
of the C-Channel.
Rear View Driver Rail
Mounting
Cleat
C-Channel
RETRAX Rail
Adjustment
screw
Bolt
FOR STEP 5 ON STANDARD INSTRUCTIONS:
Continue with the standard
instructions at step 4 (pg. 2)
STEP 2: Insert mounting cleats