Installation Manual

Pg. 20
Toyota Tacoma 2016-up
STEP 4: Bolt rails to pickup bed rails
STEP 5: Adjust rails to maintain parallel rails
If rails are too far apart add 0.050 shim between rail and aluminum spacer . Continue adjustment until rails are parallel. Shim
is circled in red.
0.050 shim
5’ model
0.050
6’ model
Make certain the rails are parallel - see page 3 at step 6. If not, see adjustments below.
Align cleat
and thread
bolt here
5’ model
3/8-16 x 1.50L
fastener,
Use 9/16”
wrench
Cleat
Passenger side rail
Bed rail cap
3/8 split washer
6’ model
Align cleat
and thread
bolt here
3/8-16 x 1.50L
fastener, Use
9/16” wrench
Passenger side rail
Bed rail cap
Cleat
3/8 split washer
Continue with standard instructions at step 8 (pg. 4)
Continue with standard instructions through step 6 (pg. 2) DISREGARD STEP 5,
then refer back to this guide on how to install and adjust the mounting hardware.