Installation Manual

Pg. 1
Pre-assembly Guidelines
Please read and follow instructions before un-boxing and assembling the bed cover.
Keep boxes and packing until installation is complete. Unpack carefully to prevent scratching.
DO NOT remove protective films from cover and canister until after installation is complete.
DO NOT LUBRICATE OR USE LOCTITE ON RETRAX !! (VOIDS WARRANTY)
See Maintenance page for proper care.
If you have the POWERTRAX cover please see pages 7 & 8 for special installation!
F
E
G
D
C
A
B
Parts in large box
 Instruction packet
 Cover rolled into canister-spiral assembly
 Front cover for canister
 Keys
 Drain tube kit
Parts in rail box
 Driver side rail
 Passenger side rail
 Clamp box (NOTE: Clamps in box may
vary from photo)
Clamp Box and Drain Tube Kit
(2) rubber washers A
(2) drain tubes B
(4) clamps (6 clamps for 8’ beds) C
(2) 10-24 x 3/4” font cover
mounting screws
D
(4) 10-32 x 7/16” rail to canister
mounting screws
E
6mm Allen wrench F
1/8” Allen wrench G
Tools Required
 #2 Philips screwdriver
 9/16” or 1/2” wrench (ratchet works best)
 Pliers or vice grips