Installation Manual

Pg. 18
Toyota Tacoma 2016-up
Check the parts shown here, this model has different requirements than the standard parts.
RECOMMENDED FOAM (5’ model only)
Remove film from the canister on the 5’ model only, before installation.
On the 5’ model, there is an aluminum lip that sticks out on the bottom of the canister.
The supplied foam pieces are recommended to prevent scratches on your truck.
With the edge of the cover facing you, roll the canister 90° away from you. The foam
will line up with the rear-bottom fold . Remove adhesive backing and apply the foam to
both sides.
Rear-bottom
fold
5’ MODEL ONLY:
Tools Required: T-30 torx driver
Remove the front tie downs in the bed. Use a T-30 torx.
5’ MODEL PARTS 6’ MODEL PARTS
(4) 1/4” flat washers
A
(4) 1/4-28 x .75 fastener B
(4) 3/8-16 x 1.5 fastener C
(4) 3/8” split washer D
(4) cleats E
(4) 0.050 adjustment shim F
(4) 1/4” flat washers A
(4) 1/4-28 x 1.5 fastener B
(4) 3/8-16 x 1.5 fastener C
(4) 3/8” split washer D
(4) cleats E
(4) 0.050 adjustment shim F
(4) plastic spacer blocks G
A
B
C
D
E
F
A
B
C
D
E
F
G
6’ model proceed to pg. 19