Installation Manual

Pg. 17
Toyota Tacoma 2005-2015
STEP 2: Insert mounting cleats
Check the part shown here, this model has different requirements than the standard parts.
STEP 1: Install front rail gasket
STEP 4: Bolt rails to pickup bed rails
Continue with the standard
instructions at step 6 (pg. 3)
Be sure foam is added to front bed rail, not the C-Channel
rail. Trim to fit.
Driver corner
Passenger corner
Remove and save the black plastic cap at the rear
of the Deck Rail track system on both sides of the
truck. Loosen and remove tie-downs or other ac-
cessories from each side.
Insert (2) mounting cleats into the track system on
each side.
Position rail spacer block and cleat in line with the
hole in the rail. Start threading bolt with washer
into cleat. Attach using a 9/16” wrench. Repeat at
other 3 mount locations. Keep rail level when
tightening bolts.
Rail spacer block
STEP 3: Lift assembled cover into bed and position
the rails
Tailgate
Protector
Tailgate
Using two people, lift the cover and place it at the very front
of the bed. Close the tailgate of the pickup.
1/8”
gap
Move the rails to achieve the 1/8” gap
using the 1/8” part at the top of the
bracket. Make certain the rails do not
move after measuring.
FOR STEP 7 IN STANDARD
INSTRUCTIONS:
If the rails are too far apart add rubber
rail adjustment spacers. Loosen the rail
mount bolt and slide spacer between
bed cover rail and rubber side of spacer
block.
(8) rubber rail adjustment
spacers
A
(4) cleats
B
(4) rail spacer blocks
C
Follow standard
instructions through step 3,
(pg. 2) then refer
back to this guide on how
to install mounting
hardware.
A
B
C