Installation Manual

Pg. 16
Nissan Titan 2004-up
STEP 2: Insert mounting cleats
Re-insert tie downs into the track. Insert 2nd
mounting cleat into track system on each side and
position it underneath the white nylons spacers
closest to the tailgate. Finish by re-inserting the
black plastic cap into the rear of the track system.
Continue with the standard
instructions at step 4 (pg. 2)
NOTE: The factory tie-downs may cause
interference with the lock when rolling.
Option 1: Use as is and push lock handle down
slightly to bypass the factory tie-downs.
Option 2: Remove the tie-downs before installation.
(disregard further reference to tie downs.)
Option 3: Smaller aftermarket tie-downs may be
utilized in place of the larger original tie-downs.
Remove and save the black plastic cap at the
rear of the Utili-track on both sides of the truck.
Loosen and slide out the movable truck tie downs
on each side of the bed. Insert (1) mounting cleat
into the track system on each side, position it
underneath the white nylon spacers closest to the
front of the bed. Important: Hole should be toward
bottom of channel.
FOR STEP 5 ON STANDARD INSTRUCTIONS:
This photo shows how the clamp will mount to the rail. It
is important to be sure that the threaded hole on the
cleat is closest to the bottom of the C-Channel.
Rear View Passenger Rail
Mounting
Cleat
C-Channel
RETRAX Rail
Adjustment
screw
Bolt
Check the parts shown here, this model has different requirements than the standard parts.
The Titan with no Utili-track uses the
clamps above. Continue with the
standard instructions on Page 1.
WITHOUT Utili-track: WITH Utili-track:
Follow standard instructions
through step 3, (pg. 2) then refer
back to this guide on how
to install mounting hardware.
The Titan that has the Utili-track uses the clamps below.
STEP 3: Re-insert tie downs and 2nd cleat
STEP 1: Remove plastic caps