Installation Manual

Pg. 15
Check the parts shown here, this model has different requirements than the standard parts.
STEP 1: Remove the bolts from existing Utili-track
rails and attach brackets
STEP 2: Lift the assembled cover into the bed
and position rails
FOR STEP 7 IN STANDARD INSTRUCTIONS:
To decrease the distance between the rails you add
spacers next to the nylon washers between the
RETRAX rail and the rail bracket. To increase the
distance between the rails you remove washers or
use thinner washers in place of the nylon spacers.
STEP 3: Attach RETRAX rails to rail brackets
Continue with standard
instructions on step 6 (pg. 3)
Use a rail bolt with lock washer and
flat washer and insert through hole
in RETRAX rail then use 1 white nylon
washer between the rail and rail
bracket. Start threading the rail bolt
into the rail bracket.
Remove all 8 white nylon rail adjustment spacers from
the rails then proceed below.
Attach all 4 rail
brackets to these
holes using the 4
bracket bolts (long
leg points up).
Frontier King Cab
Remove these bolts from both sides
Frontier Crew Cab
Remove these bolts from both sides
Nissan Frontier 2005-up
WITH Utili-track: WITHOUT Utili-track:
The Frontier with no Utili-track
uses the clamps below.
1/8” gap
Tailgate
Protector
Tailgate
Using two people, lift the cover and place it at the
very front of the bed. Close the tailgate of the
pickup. Using the 1/8” part at the top of the
supplied shipping bracket, move the rails to achieve
the 1/8” gap between the tailgate.
(4) bracket bolts A
(4) rail bolts B
(4) 1/4” lock washers C
(4) nylon washers D
(8) 1/4” flat washers E
(4) rail brackets F
Follow standard instructions through step 3, (pg. 2) then refer
back
to this guide on how to install mounting hardware.
Continue with the standard
instructions on Page 1.
A
B
C
D
E
F