Installation Manual

Pg. 12
Honda Ridgeline 2006-2015
STEP 5: Install front mount brackets STEP 6: Insert plastic plugs
Driver side front corner
Install front mount brackets as shown. Slide lock
washer onto M6 x 40mm bolt, push bolt through
hole in mount bracket and start threading into front
holes in the bed. Hold mount bracket level and
tighten using the 4 mm Allen wrench. (included)
Repeat on passenger side.
Insert black plastic plugs into middle holes. Push
the 2 supplied plugs into the 2 middle factory holes
on both sides of the bed.
STEP 9: Attach rear end to brackets
Driver side rear mount
Start rear mounting screws. Slide a flat washer onto the (2) M6
x 40mm (metric) rear mount bolts, insert bolts through holes
in rear rail brackets, then insert nylon spacer and start
threading into factory holes at rear. Use 4mm Allen wrench.
Passenger side front corner
Start threading the (2) 10-24 x 1 mounting screws w/
black caps through the front cover into the front mount
brackets. Do not tighten yet. Once rear brackets are
tight, then fully tighten front screws using a #2 Phillips
screwdriver. Fasten screw cover when finished.
STEP 7: Lift the assembled cover into the bed STEP 8: Attach front cover to brackets
Using two people, lift the cover and place it at the
very front of the bed. Close the tailgate of the pickup.