Installation Manual

Pg. 11
STEP 1: Attach adhesive to rails
STEP 4: Attach foam to tie downs
STEP 2: Remove factory bolts
Honda Ridgeline 2006-2015
STEP 3: Remove factory screws
Remove the adhesive
backing paper from
under the front of both
rails.
Push the front seal firmly
into place over the
adhesive keeping the
seal even.
Driver side front corner
Remove the factory bolts from both corners of the
front wall of the bed. Use #40 Torx bit. (included)
Driver side rear corner
Remove factory screws and spacers from both rear
posts using #40 Torx bit. Drivers’ rear corner is shown.
Passenger side front corner
Remove the adhesive backing paper from the foam
fillers for the tie-downs. Push into place over the tie
-down bolts. Repeat on drivers side.
Continue with standard
instructions through step 3 (pg.
2), then return back to this guide
on how to install the mounting hardware.
4mm Allen wrench
F
#40 Torx insert bit
G
(2) foam fillers for front tie
-downs
H
(2) plugs for middle holds
(step 8)
I
(2) front mounting
brackets
J
Newer models may need
rubber spacer at
passenger rear mount
K
(4) M6 x 40mm (metric)
Allen head mounting bolts
A
(2) 1/4” lock washers
B
(2) 1/4” flat washers
C
(2) nylon spacers
D
(4) 10-24 x 1” stainless
screws with black caps
E
A
B
C
D
E
F
G
H
I
J
K
Check the parts shown here, this model has different requirements than the standard parts.