Owners manual

STEP 8 Install the rear set of clamps. Attach the rear set of clamps. Push down on the rail
as you tighten the clamp bolts for a better seal on top of the pickup box rails. The rear of the rail may
need to be tilted up or down for best fit over the tailgate or tailgate protector.
STEP 7 Install the front set of
clamps.
Start with the two clamps clos-
est to the canister.
If your model has two sizes
of clamps, the clamps for the front are marked CAB.
Proper clamp location is between the two
adjustment screws. The adjustment
screws are set at different depths depend-
ing on your model. These screws may be
adjusted later. DO NOT ADJUST NOW!
The clamps should be installed as high up
as possible to engage more teeth on the
rail. Using a 9/16” wrench, tighten the
clamps. If the clamp wants to rotate while
tightening, hold with pliers or vice-grip.
Deck Rail System
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rear View Driver Rail
Mounting
Cleat
C-Channel
RETRAX Rail
Adjustment
screw
Bolt
Figure 3
FOR Deck Rail System ONLY
STEP 7R
Figure 3 shows how the
clamp will mount to the rail.
It is important to be sure
that the threaded hole on the
cleat is closest to the bottom
of the C-Channel.