Owners manual

Note: Keep rails from moving
once in position 1/8" from the
tailgate.
1/8” gap
here
Tailgate
Protector
Tailgate
View of driver rail
driver rail
STEP 6 Position the
cover.
Move the rails
forward or back to achieve
a 1/8" gap between the
bottom notch of the rail
and the inside face of the
closed tailgate or tailgate
protector. Measure both
sides. Use the supplied
1/8” thick measurement
tool to achieve the correct
1/8" gap.
Note: Plastic bed liners may have to be cut at the
front of bed so the bed cover can be moved forward
to achieve proper 1/8” clearance at the tailgate.
STEP 5-Ra For Deck Rail systems refer
to the information below before lifting cover
onto truck
Remove and save the black plastic cap at the
rear of the Deck Rail track system on both sides
of the truck (Figure 1). Loosen and slide out
the movable truck tie downs on each side of the
bed. Insert (1) mounting cleat into the track
system on each side, position it about 15” from
the front of the bed. (Figure 2) Important:
Hole should be toward bottom of channel as
shown. Then re-insert the tie down
clamps on each side of the bed, before
inserting 2nd cleat. After putting tie downs back
into bed, insert 2nd mounting cleat into track
system on each side, positioning it approximately
8” from tailgate. Finish by re-inserting the black
plastic cap into the rear of the track system
.
Black cap
Tie down
Hole on Bottom
Fig 1
Fig 2
Step 5-Ra and STEP 5Rb is for Toyota Tundra with the Deck Rail System
STEP 5 Lift the assembled cover into the bed. Roll
the cover into the canister and push down firmly on the round-
ed end of the lock until it latches. Close the tailgate on the
pickup. Using two people, lift the bed cover by the front of the
rail and two feet to the back. Set the assembly in place at the
very front of the bed.
NOTE: The rubber weather-strip on the front cover
should lie on top of the pickup’s front rail pointed to-
wards the cab.
A latch is found on a Manual Cover Only. See PowertraxPRO
Installation Supplement on how to move electric cover.
Lift bed cover at these points
GO
FOR ALL TUNDRAS
ASSEMBLY AND INSTALLATION INSTRUCTIONS