Owners manual

STEP 3 Install the driver rail. Lift up the lock cover and open lock by pressing release button.
Pull the cover out of the canister 6”-8” (See PowertraxPRO Installation Supplement on how to
move electric cover). Caution: DO NOT allow cover to roll back into canister until rail is installed.
Repeat Step #2 to install the driver's rail. Be sure all rail mounting screws are tight.
STEP 4 Install the front
cover.
The front cover is
attached below the rails.
Hold the cover level and push
both ends in evenly to help
slide it into place. When the
holes are lined up, start
threading the (2) Front Cover
mounting screws Tighten the
2 screws securely the enclosed
1/8” Allen wrench.
SIDE VIEW OF FRONT COVER
This end towards tailgate
Weather-strip towards cab
Front Cover
STEP 5 Lift the assembled cover into the
bed.
Roll the cover into the canister and push down
firmly on the rounded end of the lock until it latches.
Close the tailgate on the pickup. Using two people, lift
the bed cover by the front of the rail and two feet to
the back. Set the assembly in place at the very front
of the bed. GO TO STEP 6
NOTE: The rubber weather-strip on the front
cover should lie on top of the pickup’s front
rail pointed towards the cab.
A latch is found on a Manual Cover Only. See
PowertraxPRO Installation Supplement on how
to move electric cover.
Lift bed cover at these points
If truck has the Deck Rail System, please turn to
the next page and follow Step 5-Ra and Step 5-Rb.
ASSEMBLY AND INSTALLATION INSTRUCTIONS