Owners manual

Pre-assembly guidelines
Two people are recommended for installation and you should allow 1 to 1 ½ hours to complete.
Floor space about the size of pickup box is needed for assembly of the bed cover and rails.
Clear out the pickup box and clean the front and side bed rails.
Plastic bed liners may have to be cut or notched at the front of the bed if they touch the rolling
cover or interfere with proper canister location. A jig saw with medium tooth blade or a Dremmel or Roto-Zip
tool works well. The front lip of the bed liner should be cut off if side bed rail caps are not installed.
Drain tubes (2) 1/2" drain tubes connect to the bottom of canister and can exit out the floor or front of the pickup
bed. Some pickups have drain holes in the front of the bed towards each corner; others have plastic or rubber
plugs that can be drilled for the tubes. If needed a 1/2" hole can be drilled into both front corners of the box.
For pickups equipped with plastic bed-liners, holes for the drain tubes need to be drilled through the plastic only.
We recommend drilling additional holes through the floor of a plastic bed liner at the lowest points in front to
allow for water drainage.
STEP 1 Remove the shipping bracket and yellow wire.
Completely remove white shipping tubes.
Shipping tube Shipping bracket
Remove these items only!
The shipping brackets can be disassembled
simply by removal of the 10-32 screws
fastened to each side of the canister
(Remove these items only). The tail-
gate can then be lifted away from the canis-
ter allowing for the removal of the shipping
bracket by sliding the T-channel out from
the wire ties. The wire ties can then be
removed from the bearings without the
need for cutting the wire. Pull white ship-
ping tubes completely out of the
canister.
DO NOT ALLOW THE COVER TO ROLL
INTO THE SPIRAL BECAUSE THE
BOTTOM OF THE LOCK CAN DAMAGE
Driver side view of assembly
ASSEMBLY AND INSTALLATION INSTRUCTIONS