Owners manual

Parts checklist for large box
Instruction packet
2 keys with key chain
Cover rolled into canister-spiral assembly
Front cover for canister
Drain tube kit
Thank you for your purchase of the
RETRAX™ bed cover system.
Please read and follow instructions before un-boxing and assembling the bed cover.
Check for shipping damage.
Keep boxes and packing until installation is complete.
Unpack carefully to prevent scratching.
Remove protective films from cover and canister after installation is complete.
Remove the protective plastic films before exposing to direct sunlight.
Do Not lubricate RETRAX—See Maintenance page for proper care.
If you have any questions or concerns please call 800-206-4070 or e-mail [e-mail]
Tools Needed
#2 Philips screwdriver
9/16” wrench (ratchet works best)
Pliers or vice grips
Parts checklist for rail box
Driver side rail
Passenger side rail
Clamp box including;
(4) Clamps (8 ft models use 6 clamps)
(4) Rail to Canister mounting screws 10-32 x 7/16” Stainless Phillips head
(2) Front Cover mounting screws 10-24 x 3/4” Black Stainless Allen head
(1) 1/8” Allen head wrench (1) 1/8” measuring tool (1) 1/4” Allen head (hex) wrench
The Tundra comes with
or without the Deck Rail
Cargo Management
System.
If the Tundra does not
have the deck rails,
then the mounting
hardware used is shown
in Figure 1
If the Titan does have
the deck rails, then the
mounting hardware
used is shown
in Figure 2
DO NOT USE LOCTITE!
USE OF LOCTITE VOIDS
WARRANTY
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Figure 1
Figure 2