Owners manual

STEP 2 Install the passenger rail to the spiral.
Rear attachment hole
Lift up the lock cover and open lock by pressing release button.
Front attachment hole
Bearings enter
channel of rail
here.
Start sliding the cover and bearings
into the channel of the rail.
View from drivers side View from passenger side
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Passenger rail has “inspected by” sticker
under the front of the rail
STEP 1 Remove the shipping bracket and yellow wire.
Completely remove white shipping tubes.
The shipping brackets can be disassembled
simply by removal of the 10-32 screws
fastened to each side of the canister
(Remove these items only). The tail-
gate can then be lifted away from the canis-
ter allowing for the removal of the shipping
bracket by sliding the T-channel out from
the wire ties. The wire ties can then be
removed from the bearings without the
need for cutting the wire. Pull white ship-
ping tubes completely out of the
canister.
DO NOT ALLOW THE COVER TO ROLL
INTO THE SPIRAL BECAUSE THE
BOTTOM OF THE LOCK CAN DAMAGE
THE COVER!
Shipping tube Shipping bracket
Remove these items only!
Driver side view of assembly